TAMIYA 1/10 FIAT ABARTH 1000 TCR (NO ESC) (T58721HV)
This is a fantastic mixture of the old and the new. Tamiya’s latest and greatest MB01 M-chassis combined with the classic micro beast, the Fiat Abarth. The race ready Fiat shell is faithfully reproduced as always with Tamiya cars and has the iconic ‘boot up’ stance that is the hallmark of racing 500’s. Our Hearns car has box art paint of lame flaked Corsa Grey, complimented with fluorescent orange and also a fully detailed engine which will guarantee you maximum style points at the track. Check it out!
The MB01 chassis is set up as a FWD but can also be converted to RWD in just a couple of minutes.
Its fully ball-raced and comes with a Highest 550T servo and esc. You just need to add a transmitter, receiver, battery & charger, and you’re off!
Sold as is.
Built over 6 hours by Brett, TFG and BJ.
Has been run a few times.
See all of the build videos on YouTube: Tamiya MB 01 Fiat Abarth 1000 TCR Build videos
TAMIYA 1/10 FIAT ABARTH 1000 TCR
The origin of M-chassis series history goes back to December 1994, and this series has been popular due to cost-effective kits with a wide choice of bodies, ease of maintenance and control for any level user. Enter, the all-new MB-01!
The new MB-01 chassis continues that tradition and allows six setups by choosing from three types of wheelbases, and front- or rear- wheel drive system. Its first body recreates the Fiat Abarth 1000 TCR Berlina Corse which was a car developed with high level tune-ups based upon the compact 2-door Fiat 600.
MB-01 Chassis Features
Length: 322mm, width: 163mm. Wheelbase: 209mm (S) / 224mm (M) / 239mm (L) (*Fiat Abarth uses the LONG wheelbase setup).
The multi-purpose, 2WD MB-01 chassis gives choices of three types of wheelbases (*), and front- or rear- wheel drive system. Six setups are available in total.
Simply change attachment directions of final gears and steering linkage to switch between front- and rear- wheel drive; low or high motor position can be chosen for rear-wheel drive cars.
Unitized sections such as motor mount and final gears facilitate ease of assembly and effective maintenance.
The 4-wheel double wishbone suspension features symmetrical structure and friction dampers.
While this is a 2WD model, multi-link suspension is compatible with tires featuring the same compound and rear tire with toe-in as 4WD models.
Gear ratio: 5.83:1 (when using kit-standard 29T pinion gear)
Features 55mm diameter front tires and 60mm diameter rear tires to authentically recreate the stance of the actual car.
Many Hop-Up Option parts for M-chassis and TT-chassis cars can be used to fine-tune setup.
Includes 540 motor.
Requires 2-channel radio, 7.2-7.4volt battery with compatible charger to complete.